Glove/Hood Dryer
by on Sep.17, 2010, under Glove Hood/Dryer, Howto
What you will need:
1) 1 piece of board 2x2x2 18 inches long
2) 2 peices of 1 inch hemlock dowel 13.5 inches long
3) Drill
4) 1 inch drill bit
5) Wood glue
Getting started:
1) Start by cutting your piece of 2x2x2 so that it is about 18 inches long.
2) Then using your 1″ drill bit and drill a hole in the center of the board 4.5″ inches from the end.
3) Then drill another hole 4.5″ from the other end.
Note: When drilling your holes, only drill about 3/4 of the way through the board. You want the hemlock dowel to have a good seat but you don’t want to drill right through the board.
4) Take your wood glue and glue the inside of the holes you just drilled.
5) Take pieces of dowel and place them into the holes.
6) Glue should be dry in approximately 4hrs.
