Noel's Dive Blog

This is a pretty funny video i found on one of the forums. The diver finally does get it. If you listen closely I swear you can hear the camera diver laughing.

What you will need:
1) 2 pool noodles Note: 2 pool noodles will make a tank rack big enough for 3 tanks.
2) 20ft of yellow nylon rope
3) Drill with drill bit (the aproximate size of the rope)
4) Saw
5) Scissors

Getting started:
1) Cut your pool noodles into 4 11.5″ pieces.
2) Into each cut piece of pool noodle, drill 2 holes approximately 5″ from each end.

3) Take your nylon rope and a piece of 11.5″ pool noodle and feed the rope through the hole. If you are kneeling and noodle is in front of you, you should start feeding the rope through the hole from right to left. Then take the same end and feed it over top and back into the right hole.

4) Take another piece of 11.5″ pool noodle and place it next to the first one. I found the best way to measure the distance between noodles is to lay a tank down between them. Once you have measured the distance you want between the noodles, take the rope and feed it through the next top hole; this time going from left to right. Take the rope and pull it over the top of the noodle and feed it through the same hole; again going from left to right.

5) Repeat the process until all of the top holes are done.



6) Once you get to the last top hole on the top wrap the rope through the hole and cut it off.
7) Start the first bottom hole the same as you did for the top hole; start by feeding the end through the first bottom hole going from right to left, pull the rope over the top and feed it through the hole tucking it in.
8 ) Take the other end of the rope and feed it into the second pool noodle going from left to right.

9) Repeat the process until the rope is through all of the bottom holes.

Note: You can substitue the pool noodle with PCV pipe. I went with pool noodles as they are much cheaper.

What you will need:
1) 1 piece of board 2x2x2 18 inches long
2) 2 peices of 1 inch hemlock dowel 13.5 inches long
3) Drill
4) 1 inch drill bit
5) Wood glue

Getting started:
1) Start by cutting your piece of 2x2x2 so that it is about 18 inches long.
2) Then using your 1″ drill bit and drill a hole in the center of the board 4.5″ inches from the end.

3) Then drill another hole 4.5″ from the other end.

Note: When drilling your holes, only drill about 3/4 of the way through the board. You want the hemlock dowel to have a good seat but you don’t want to drill right through the board.

4) Take your wood glue and glue the inside of the holes you just drilled.
5) Take pieces of dowel and place them into the holes.

6) Glue should be dry in approximately 4hrs.

You can sign a petition to help stop the dolphin slaughter from The Cove. From the website “Everyone who signs the letter will be able to have their name displayed in a widget that will be posted on top social networks, web sites and blogs in Japan.”

The Cove Trailer:

Blood Dolphins:

Incredible video. You can follow the official twitter feed here.  The expedition site.

These are the pictures we ordered from Finphoto when diving with Stuart Cove’s.